Thank you so much for the help. I was close, but was missing the layout
attributes on the inner table.
What technique do you suggest for right-aligning, after aligning on the
decimal? I assume I would want the third inner cell to be limited to
the width of the value with the maximum precision (and largest
font-size), but I haven't had luck with that, either.
+-------------+
| My Column|
+-------------+
| 123.123 |
| 1.1234|
| 12345.1 |
| 12.12 |
+-------------+
Thanks!
Angela
-----Original Message-----
From: owner-xep-support@renderx.com
[mailto:owner-xep-support@renderx.com] On Behalf Of Alexei Gagarinov
Sent: Thursday, September 06, 2007 4:18 PM
To: Angela Williams
Subject: Re[2]: [xep-support] RE: Calculate mid-point of column using
inherited-property-value
Hi Angela,
> You would not need to specify the center (.4in) if
> "inherited-property-value(column-width)" was valid.
The 'inherited-property-value' function does not work with attributes
from the 'table-column' element by its design.
The correct property function for this task is the 'from-table-column'
function.
'from-table-column(column-width)' gives your the desired result for
absolute column widths only, XEP does not support this function for
proportional column widths.
Though it may be considered as a bug in XEP, but this failure with
proportional column widths will save you :)
--- The described layout - centered alignment on a dot - will look poorly using the proposed design, if table cells have text with different font properties. The clearest solution is to wrap each cell into the inner table. <fo:table-cell> <fo:table table-layout="fixed" width="100%"> <fo:table-column column-width="proportional-column-width(1)"/> <fo:table-column column-width="1em"/> <fo:table-column column-width="proportional-column-width(1)"/> ... </fo:table> </fo:table-cell> The first inner cell is for a part of text before a dot, the middle cell is for dot, and the last cell is for a part of text after dot. The first inner cell should be "end" aligned, the last cell should be "start" aligned. The only drawback of this solution is loss in performance. > Thanks! > Angela Best regards, Alexei Gagarinov RenderX --- www.renderx.net ------------------- (*) To unsubscribe, send a message with words 'unsubscribe xep-support' in the body of the message to majordomo@renderx.com from the address you are subscribed from. (*) By using the Service, you expressly agree to these Terms of Service http://www.renderx.com/terms-of-service.html ------------------- (*) To unsubscribe, send a message with words 'unsubscribe xep-support' in the body of the message to majordomo@renderx.com from the address you are subscribed from. (*) By using the Service, you expressly agree to these Terms of Service http://www.renderx.com/terms-of-service.htmlReceived on Thu Sep 6 16:19:50 2007
This archive was generated by hypermail 2.1.8 : Thu Sep 06 2007 - 16:19:51 PDT